RE-606

I´m a Alpha Builder, more infos later.

Build Guide:

BOM:

http://23.235.199.139/~re303c5/forum/topic/1276-some-hints-from-building-my-re-606/

• Mainboard
  • CR97 -> R97 and use C110
• Tom board:
  • CR305 ->  R305 and use C329
  • CR308 -> R308 and use C330

• The jumper wire strip from the alpha BOM was slightly too short, looks like it was updated in the latest BOM to 3 inch, but I would recommend maybe even getting the 4inch instead of 3inch :
  • 571-FSN-23A-8 (Mouser)
• The scale switch - while this is by no means correct, this will work - just need to wire it to the board, and its quite small compared to the hole in the cases etc
  • 611-SS-24E06-TG5P (Mouser)

BOM help:

Fuse Resistor 2.7ohm = R237 in PSU:

Mouser:  PR02FS0202708KR500

TME: NFR1W-2R7

Tipps:

in case you dont have the SCALE Switch and want test the RE606 with a Workaround (Bridge Pins instead of a Switch)

, you have to Bridge the switchchassis holes with a cable at the outer mounting holes (same in Re303 ) - otherwise the GND pads/traces of the Instruments  are not connected