Project
Projecttitel: RE-606
Status: ALPHA BUILD
Startdate: 11/2019
Duedate: 01/2020
Manufacture link:https://shop.re-303.com
I´m a Alpha Builder, more infos later.
Build Guide:
BOM:
http://23.235.199.139/~re303c5/forum/topic/1276-some-hints-from-building-my-re-606/
- Mainboard
- CR97 -> ignore R97 and use C110
- Tom board:
- CR305 -> ignore R305 and use C329
- CR308 -> ignore R308 and use C330
- The jumper wire strip from the alpha BOM was slightly too short, looks like it was updated in the latest BOM to 3 inch, but I would recommend maybe even getting the 4inch instead of 3inch :
- 571-FSN-23A-8 (Mouser)
- The scale switch - while this is by no means correct, this will work - just need to wire it to the board, and its quite small compared to the hole in the cases etc
- 611-SS-24E06-TG5P (Mouser)
BOM help:
Fuse Resistor 2.7ohm = R237 in PSU:
Mouser: PR02FS0202708KR500
TME: NFR1W-2R7
Tipps:
in case you dont have the SCALE Switch and want test the RE606 with a Workaround (Bridge Pins instead of a Switch)
, you have to Bridge the switchchassis holes with a cable at the outer mounting holes (same in Re303 ) - otherwise the GND pads/traces of the Instruments are not connected