I reworked a PSU design, because the most bipolar psu pcbs doesn't match with my requirements.
This Psu is great in combination with an Yamaha PA-30, perfect for the TTSH - no EMV problems or hum from the switching DC solution and no hum on the reverb.
The Yamaha PA-30 gives you around 700mA on 15V and 700mA on -15V.
Inputs and Outputs are mechanical very stable and the pcb can be attached by 6 Screws.
a DPDT switch connect/disconnect the power (a standard MTA156 4 pole header is used here)
The Voltage regulators can be mount directly (with isolation/glimmer pads) on a metal case like the TTSH or with cooling frames.
you can use MTA100 headers instead of the LEDs - to connect 1 or 2 external Led holder in your device.
Its important to double check every rectifier/diode and capacitor and your wiring before you test the circuit.
BOM: (first version)
BOM_PSU_rev1.0_2020-08-09_17-15-03.xls
Build:
just install all parts from the BOM.
Fuse sizing:
use at the input fuses (F1/F2) the value which your AC-AC transformer offer - for the Yamaha PA.30 its max. 750mA (500mA/630mA should be fine)
for the secondary fuse use a value which is 10-20% bigger than what your device ask (for example a TTSH works great with 2x 500mA fuses and should be work with a 320mA too (depends on the additional mods)