Projecttitel: MME Minimoog Clone guinguin
Status: DONE
Startdate: 07 Aug.2017
Duedate: 23.08. 2017
Manufacture link: https://guinguin-instruments.github.io/MME
Manufacture link: https://guinguin-instruments.github.io/MME
Shop:
https://guinguin-instruments.ecwid.com/
rare Parts Kit (included with the pcb/panel ordering since 06/2018) or ask Julien
3x LM3046M
3X 2N3954 (tested)
3x 2N4402 (tested)
2x BF245 (tested)
3x 2N3954 (tested)
3x 1K Tempco
muffwiggler thread:
https://www.muffwiggler.com/forum/viewtopic.php?t=126711&postdays=0&postorder=asc&start=1175
modified BOM: (my BOM list)
check for the original BOM: https://guinguin-instruments.github.io/MME
I ordered from: TME, mouser, thonk and musikding
my mouser cart: http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=0901ddef92
this cart is limited to my own usage for one device - you need to order standard parts like resistors from another source to save money.
for male/female headers use a different brand or headers with more pins in case they're out of stock.
order 10 resistors instead of 2 and you'll get the better price.
supplier | |||
---|---|---|---|
mouser | 92€ | ||
tme | 45€ | ||
thonk | 20€ | ||
musikding | 40€ | ||
homestock parts | 20€ | ||
mouser trannys und 4402,bf245 | 60€ | ||
TOTAL | ca.280€ |
not including all ic-sockets
- Don´t install the header as described at the beginning of the build - otherwise you run in trouble ( normally is the process: put the male and female header together, put it on one board and use spacers and screws to hold this in correct place/alignment,
then solder the male/female header. this is the only way to get a correct alignment of the pcbs and frontpanel.
2. solder the 4x TL1963 and lm2991 not to close together - or you risk a short between the solder points or regulators.
3. use matched transistor pairs as described in the buildguide, but from my pov. you cant match a 2N3904 and 2N3906 to the same value.
make sure you installed a jumper on JP10(2pins) and JP19 (3pins) (bridge the second and third pin with a PC jumper)
There are no images attached to this page. |
(my analog board picture shows my build with one failure - near the 2N4402 are 56K instead of 56R in the picture)