Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Projecttitel: RE-606Status:
Startdate: 11/2019Duedate: 01/2020Manufacture link:https://shop.re-303.com |
...
Build Guide:
View file | ||||
---|---|---|---|---|
|
...
RE606_BOM.v1.3.2-RLS.xlsx (latest version with mouser part numbers)
Cases are bought by kumptronics
CPU was from pixie (included in the RE-606 pcb order)
mouser card: (not approved from me)
...
http://23.235.199.139/~re303c5/forum/topic/1276-some-hints-from-building-my-re-606/
- Mainboard
- CR97 -> R97(4k7) and use C110 (1NF parallel)
- Tom board:
- CR305 -> R305 (4K7) and use C329 (1nf parallel)
- CR308 -> R308 (4K/) and use C330 (1nF parallel)
- The jumper wire strip from the alpha BOM was slightly too short, looks like it was updated in the latest BOM to 3 inch, but I would recommend maybe even getting the 4inch instead of 3inch :
- 571-FSN-23A-8 (Mouser)
- The scale switch - while this is by no means correct, this will work - just need to wire it to the board, and its quite small compared to the hole in the cases etc
- 611-SS-24E06-TG5P (Mouser)
...
Discussion about the Scale switch: http://23.235.199.139/~re303c5/forum/topic/514-unobtainium-re606-pre-scale-switch/?tab=comments#comment-12104
Install CR97 (1nF) and R106 from the bottom side otherwise the Mode Switch will not fit.
BU -battery Wire port 28 (not sure what to expect here but I measured somewhere around 6VDC iirc)
6VDC Wire port 30
15VDC Wire port 33
5VDC Wire port 34
Issues:
Issue 1: (see service notes from Roland to check the correct layout)
...
C3= C403 100uF/16V electrolyte polar
CPU update/firmware/bootloader
in case you want upgrade the firmware, you have to update the bootloader.
I´dont give support about the update processes since I bricked my CPU while updating it and ended in a installation of an original CPU
https://github.com/sunflowr/recpu/releases
1.4.3 Version:
bootloader: bootloader.1.4.3.syx
REEMU reemu.1.4.3.syx
1.30: don't use it (buggy)
1.20 Version
bootloader: bootloader.syx
REEMU: reemu.syx