Page History

Image Removed

Image Added

Manufacture link: https://guinguin-instruments.github.io/MME

...

Shop:

https://guinguin-instruments.ecwid.com/

rare Parts 

3x LM3046M  ask me if you can't find it

3X 2N3954 (tested) avaiable on diysynth.de

3x 2N4402 (tested)    ask me if you can't find it

2x BF245  (tested)    ask me if you can't find it

3x 1K Tempco avaiable on diysynth.de

muffwiggler thread:

https://www.muffwiggler.com/forum/viewtopic.php?t=126711&postdays=0&postorder=asc&start=1175

...

modified BOM: (my BOM list) 

minimoog.xlsx 

check  for the original BOM: https://guinguin-instruments.github.io/MME

All.ods.  you can also use this file and open it with  OpenOffice - export it to a CSV file and import it on mouser import tool.  

I ordered from: TME, mouser, thonk and musikding

...

this cart is limited to my own usage for one device - you need to order standard parts like resistors from a other another source to save money. 

for rotary switch use from mouser this, the part on the gui guin BOM isn´t available:

105-SR2511F-26FN

105-SR2511F-34FN

 

for male/female header headers use other a different brand or headers with more pins if in case they're out of stock, .

Info
order 10 resistors intead instead of 2 and you'll get the better price.

 

...

supplier
mouser	92€
tme	45€
thonk	20€
musikding	40€
homestock parts	20€
mouser trannys und 4402,bf245	60€
LS3954	15€
TOTAL	ca.295€

 

 

exclusive all ic-scockel, standard widerstände, 2N3904/06, 1uf, 10uf, 4,7 caps, knobs, washer,screws, TL072,

 

homestock: lm1963AKTTR 2

lm1963adcqr 4

mps8097 100

1n458a 10

2n546120

2n4058 100

2n4401 10

4402 ca.25

bf245 30

2n3392 200

 

280€

not including all ic-sockets

Panel
title Build Notice
Don´t install the header as described at the beginning of the build - otherwise you run in trouble ( normally is the process: put the male and female header together, put it on one board and use spacers and screws to hold this in correct place/alignment, then solder the male/female header. this is the only way to get a correct alignment of the pcbs and frontpanel. 2. solder the 4x TL1963 and lm2991 not to close together - or you risk a short between the solder points or regulators. 3. use matched transistor pairs as described in the buildguide, but from my pov. you cant match a 2N3904 and 2N3906 to the same value. make sure you installed a jumper on JP10(2pins)  and JP19 (3pins) (bridge the second and third pin with a PC jumper)

Gallery

(my analog board picture shows my build with one failure - near the 2N4402 are 56K instead of 56R in the picture)