Cookie Information, please respect my cookie handling while usage this website, or close this session. click here

Page History

Versions Compared

Key

This line was added.
This line was removed.
Formatting was changed.

Panel

borderColor	#000000
bgColor	#f0f0f0
titleColor	#FFFFFF
titleBGColor	#4C5356
title	Project

Projecttitel: MME Minimoog Clone guinguin

Status:
Status
colour Green
title done

Startdate: 07 Aug.2017

Duedate: 23.08. 2017

Manufacture link: https://guinguin-instruments.github.io/MME

Manufacture link: https://guinguin-instruments.github.io/MME

...

Shop:
https://guinguin-instruments.ecwid.com/

i offer a MME rare Parts Kit :(included with the pcb/panel ordering since 06/2018) or ask Julien
3x LM3046M
3X 2N3954 (tested)
...
3x 2N3954 (tested)
3x 1K Tempco
https://www.diysynth.de/product_info.php?language=en&currency=EUR&info=p27_mme-rare-parts-kit.html

if you need knobs or single parts LM3046M or rare Parts (2N4402, BF245, 2N3954 ), feel free to visit my shop:
https://www.DIYsynth.de

muffwiggler thread:
https://www.muffwiggler.com/forum/viewtopic.php?t=126711&postdays=0&postorder=asc&start=1175
...
check for the original BOM: https://guinguin-instruments.github.io/MME

I ordered from: TME, mouser, thonk and musikding
...
this cart is limited to my own usage for one device - you need to order standard parts like resistors from another source to save money.

for male/female headers use a different brand or headers with more pins in case they're out of stock.

Info
order 10 resistors instead of 2 and you'll get the better price.
...

supplier

mouser 92€

tme 45€

thonk 20€

musikding 40€

homestock parts 20€

mouser trannys und 4402,bf245 60€ LS3954 15€

TOTAL ca.295€

280€

not including excluding all ic-sockets, standard resistors, 2N3904/06, 1uf, 10uf, 4,7 caps, knobs, washers,screws, TL072s,

Panel
title Build Notice
Don´t install the header as described at the beginning of the build - otherwise you run in trouble ( normally is the process: put the male and female header together, put it on one board and use spacers and screws to hold this in correct place/alignment,
then solder the male/female header. this is the only way to get a correct alignment of the pcbs and frontpanel.
2. solder the 4x TL1963 and lm2991 not to close together - or you risk a short between the solder points or regulators.
3. use matched transistor pairs as described in the buildguide, but from my pov. you cant match a 2N3904 and 2N3906 to the same value.

make sure you installed a jumper on JP10(2pins) and JP19 (3pins) (bridge the second and third pin with a PC jumper)
...

Gallery
(my analog board picture shows my build with one failure - near the 2N4402 are 56K instead of 56R in the picture)

homestock:
mps8097 100
1N458a 10
2N5461 20
2n4058 100
4402 ca.25
bf245 26
2n3392 200