Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Projecttitel: MME Minimoog Clone guinguinStatus:
Startdate: 07 Aug.2017Duedate: 23.08. 2017Manufacture link: https://guinguin-instruments.github.io/MME |
Manufacture link: https://guinguin-instruments.github.io/MME
...
Shop:
https://guinguin-instruments.ecwid.com/
i offer a MME rare Parts Kit :(included with the pcb/panel ordering since 06/2018) or ask Julien
3x LM3046M
3X 2N3954 (tested)
...
3x 2N3954 (tested)
3x 1K Tempco
https://www.diysynth.de/product_info.php?language=en¤cy=EUR&info=p27_mme-rare-parts-kit.html
if you need knobs or single parts LM3046M or rare Parts (2N4402, BF245, 2N3954 ), feel free to visit my shop:
muffwiggler thread:
https://www.muffwiggler.com/forum/viewtopic.php?t=126711&postdays=0&postorder=asc&start=1175
...
check for the original BOM: https://guinguin-instruments.github.io/MME
I ordered from: TME, mouser, thonk and musikding
...
this cart is limited to my own usage for one device - you need to order standard parts like resistors from another source to save money.
for male/female headers use a different brand or headers with more pins in case they're out of stock.
Info |
---|
order 10 resistors instead of 2 and you'll get the better price. |
...
supplier | |||||||||
---|---|---|---|---|---|---|---|---|---|
mouser | 92€ | ||||||||
tme | 45€ | ||||||||
thonk | 20€ | ||||||||
musikding | 40€ | ||||||||
homestock parts | 20€ | ||||||||
mouser trannys und 4402,bf245 | 60€ | LS3954 | 15€ | ||||||
TOTAL | ca.295€ |
280€ |
not including excluding all ic-sockets, standard resistors, 2N3904/06, 1uf, 10uf, 4,7 caps, knobs, washers,screws, TL072s,
Panel | ||
---|---|---|
| ||
then solder the male/female header. this is the only way to get a correct alignment of the pcbs and frontpanel. 2. solder the 4x TL1963 and lm2991 not to close together - or you risk a short between the solder points or regulators. 3. use matched transistor pairs as described in the buildguide, but from my pov. you cant match a 2N3904 and 2N3906 to the same value. make sure you installed a jumper on JP10(2pins) and JP19 (3pins) (bridge the second and third pin with a PC jumper) |
...
Gallery |
---|
(my analog board picture shows my build with one failure - near the 2N4402 are 56K instead of 56R in the picture)
homestock:
mps8097 100
1N458a 10
2N5461 20
2n4058 100
4402 ca.25
bf245 26
2n3392 200