Here starts my own Building Documentation /Steps and Modification.
last Modification Date: 19.03.2014
BOM from me: BOM TTSH modificated
Dokumentation: http://thehumancomparator.net/building/
pdf. Dokumentiton and calibration guide (at the end) : http://www.guyd2.com/ttsh-buildpocket.pdf (doublecheck the PSU/Polarization issue)
Schematic: TTSH-schematics.pdf (also avaiable on zthees webserver)
STATUS pcb finished, all fader mounted - ready for calibration
ATTENTION - wiring from PSU to the module headers are wrong "silkreen error" +/- must crossed - doublecheck before power up modules
Please read the Buildings tips to save time
Dont solder switches, Pushbutton, faders and jacks prior finally assembly - the orientation is only correct by placing all jacks/faders..
Result from Widy/DSL-man:
1x 150K S&H missing ( not in building doc)
1x100p (missing part )
first TTSH Kit arrived on 05.03.2014
TIP: check the pcb for failures !
Starts soldering the VCO Boards:
Online building documentation failure:
for VCO pcbs in zthees building website shows 1x61k9 but needed on each pcb 2x 61k9 resistors
http://thehumancomparator.net/4027-2/
Start assembly Main PCB
Use standoffs/Spacers:
Mounting VCO-1 pcb with long headers, but solder before 150K & 3m3
( i use only long headers)
PSU with DC-DC Voltage "regulator"
right picture shows the X-crossed ferrite bead to fix the -15/+15V silkscreen error
VCO testing - wiring a +15v cable to resistor and probe ..
see my solution..
VCF picture - handle with care - 2n3904/06 - BC558 doublecheck the position near Tempco 2h
AR/ADSR
VCA
for testing: test with probe a VCO (need +15V cable see VCO testing above)
feed the VCO signal to the VCA and check the waveform with a oscilloscope.
Ringmod, Preamp, Envelope Follower
Mixer
Noise, Voltage Processor
first Panel mounting test
S/H - Clock - Noise
All Parts soldered, Panel mounted, need to solder the jacks.
Building tip:
place each row of faders on PCB and solder 2 pins, place the Panel in right way and mount all screws,-- solder the faders complete.
remove the panel and plug all jacks in position, place the panel - mount all screws and few jacks with screws - turn the device, solder the jacks.
solder the LED at last.
If you have trouble with noise leds, connect the 470r resistor near amp/noise to the unlabeled solder hole.
HUM Issue:
by using of both amplifiers for integrated speakers i have massiv hum, by touching the panel the hum sound changes. (hum is only in speakers not in main out)
a workarround from zthee, was tested by me - it helps.
i´m not really sure whats the rootcause - maybe i have a other issue in my build (but only a 47K resistor left - other builder too)
Resolution:
short out the 10Ω resistor and the 100p capacitor in the PSU section. E.g. just make a small bridge between the pad close to 10Ω and 100p as in the attached picture.
Planned Case: