The Schematics are only available for users who ordered the PCB or Module, contact me.
Module Description:
5U MOTM format 3U width (221,87mm x 132,97mm)
based on the Arp 4012 Idea
LED Slider
Resonance CV Vactrol based
easy to build
less wiring
skiff friendly
powder coated and silkscreened Aluminium panel
only 2 SMT components (led driver)
10/11mm leadspace (no bloody fingers like eurorack 7mm leadspace)
leadfree pcbs
MOTM Power header (-15V/15V)
Connections:
3 Audio Inputs
3 CV Inputs
1 Resonance CV input
1 Output
BOM:
Controlboard_1.1.8.xlsx
BOM_potted_Module_4012_v1.1.xlsx
BOM_potted_Module_4012_v1.2.xlsx one typo fixed R2 = must be 470R instead 420R
Info for rare parts:
QUANTITY | VALUE | DESCRIPTION | OTHER |
1 | 2N3958 | JFET N-Channel Dual | rare part, ask Patrick aka DSL-man/LED-man |
1 | 1k87 | Tempco | rare part, ask Patrick aka DSL-man/LED-man |
|
|
|
|
Buildguide:
Short version:
Controlboard:
start with the SMT Parts: 2 x LED driver diode on controlboard
assembly the controlboard, SW input pin 2 must be connected to SW output pin 2 (see picture)
mount all spacers for frontpanel and potted module, the 4x 12mm spacer are between controlboard and potted module, the other 4x 12mm spacer between potted pcb and DIYSYNTH cover pcb.
note: theres a LED above from the Vactrol, positive/negative is the same as the vactrol pinout marking, you can place it in the lower or upper position (its in parallel)
assembly the potted PCB:
place all resistors and 1N4148, solder this parts.
capacitors next, then IC socket, transistors.
The Ladder contains matched transistor pairs, match them to less 2mV VBE difference, or ask me for help.
test your 2N3958 tranistor and dont overheat them while soldering.
4012_potted_module.png
Note, there´s one 2N3906 on left side of the tempco (from the pair the transistor on top)
Gallery
|
There are no images attached to this page. |