This page is only for me
i dont support Main Power handling (ich supporte keine 110V/230V Basteleien)
in case of usage a 230V powersupply dont add the parts for the onboard regulator
make sure you have a Main current fuse for the powersupply, typically i use IEC power inputs with linefilter and double fuse.
use rubber feeds otherwise the case "swings with the transformer frequency", you can hear it in the big ttsh case like a speaker.
Info for users with embedded switched Murata/TDK.. regulators:
(if you have added the both switched regulators, desolder the 220nF caps, 100uH caps)
For new build:
- dont add the inductors, 47uf cap, 240R, 2k4, 4n7caps, 27k, voltage regulators, trimmer
- you only need to add: 3pin MTA156 header, run wires between TP3 and +15V and a Tp1 and -15V (see picture), (otherwise the Fader LEDs dont do his job )
for condor/power one powersupplys:
cut VW1 and VW2 on pcb, run wires at the output included sense
picture shows 230V usage (Mains Input on transformer is different for 110V AC)
measure the 15/0/-15V before you connect it to the TTSH. if needed use the psu pcb trimmer to change it to the correct value,
recalibrate your VCO V/oct and VCF 1V/oct if needed.
Gallery
no earth wiring for TTSH in Picture 1, but its needed for powerone psus.
There are no images attached to this page. |