...
This was a little tricky to figure out:
clap reverb mod -
replace r376 (47k) with 100k pot trimpot
This will vary the reverb between full and completely off.
...
Cowbell
Range: replace R44 und R45 with (xxx kOhm) and (xxkOhm).to a 50k trimmer
adjiust the trimmer on left hand - after a bleedthru you must trim one trimmer a bit more to get a cowbell.
you can doublecheck them by using a scope
http://www.e-licktronic.com/forum/viewtopic.php?f=16&t=189&start=20
Low Noise Ratio (SNR) for Mastersection
...
change in the Mastersection all carbonfilm resistors to Metallfilm resistors and change all cheap electrolyt caps to LOW ESR caps..
change the ceramic cap (220p) to a c0g capaciator
Low Noise Ratio (SNR) for Mastersection
...