Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Projecttitel:Status:Startdate: 04/2020Duedate: 06/2020Manufacture link: |
Panel and PCBs from Synthcube:
...
important: the Jack Hole Audio Out must be changed (drilling) to the panel border side otherwise the switch and jack are too close and will not fit in a correct alignment.
the following wiring do not match with the schematics ( I didn't used this wiring !!)
Schematic:
(the wiring was used by me for the Triple LPG - but you must turn the switch 180degrees that it match with the panel silkscreen)
View file | ||||
---|---|---|---|---|
|
Tip:
I used 10KA Potentiometers for the bottom mixer, I just connected from each LPG output (output jack) the signal to the bottom mixer poti, an 1K pullup resistor on the wiper