Page History

Usermanual- Configuration

The CV/gate jacks need to be unplugged while you configure the JasperIN.

1. - Configuration mode (Switch S1)
   Puts the JasperIN in configuration mode for configuration of the channel and CV input range
   
   Midi Channel Configuration:
   1) Press the learn button to put the JasperIn into configuration mode
   2) Send one midi note in the midi channel you want to set the JasperIN to respond to
   
   CV range configuration:
   1) Press the learn button to put the JasperIn into configuration mode
   2) To configure the CV input range, send one midi note in the octave listed in the following table:

   Code:

   Midi Note # | Octave | Range  0 to 11    |   -2   | 0.083v-3v 12 to 23    |   -1   | 1.083v-4v 24 to 35    |    0   | 2.083v-5v    >35      |   Any  | 3.083v-6v

2. new instruction for setup the CV volatge
   

   - Unplug CV/Gate cables
   - Press S1. The JasperIN is in learning/config mode
   - Send C-1 (1 octave below C0) MIDI note in the MIDI channel you want the Jasper to respond. This will configure the CV range to be 1.083v to 4v
   - Plug the CV/Gate cables back
   - Feed 2V to the CV
   - Adjust the trimmer until you get 1V at TP1
   

   
   
   

3. - Teensy bootloader mode (Switch S2)
   Puts the JasperIN in bootloader mode for firmware updates
   
   The USB port is currently used for uploading the code only.