In June 2017 "fuzzbass" released a new Addon for the TTSH, a Waveshaper circuit board with Suboscillator, your TTSH get with this board all waveforms at VCO 1 and VCO 3.
The Board is compatible with all TTSH Versions.
muffwiggler post:
https://www.muffwiggler.com/forum/viewtopic.php?t=180267
BOM: (updated on 21.sep.2018)
LM301 not avaiable in DIP/DIL format from mouser
http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=ab73f0713f
Build Guide
Mounting of the PCB on top of the Filtercard:
One Resistor Pin (next to the VCO1 Out) is very close with the hole for the Spacer (use plastic washers by usage of metal spacer or plastic spacer)
my build:
i tested the waveshaper board for fuzzbass in a rev.3 Version and it works great.
The pcb is mounted on top of the VCF - on 2 Spacers mounted.
if you need help i can modify your TTSH with this mod.
the Panel was prepared with white transparent tape from the front and the drilled from the front - it was easier for me to setup/mark the correct alignment from front.
I used thonkicon jacks instead of the supplied jacks (with the pcb)
i only used the Suboscillator output jack and the Suboctave switch (no offset switch, external source jack)
There are no images attached to this page. |