The Firmware is still beta but official released, please check this page weekly for a stable release candidate to avoid trouble with functions and calibration.
User Manual:
tbd. by BC
Firmware:
04.Nov.2022:
new beta including vintage presets
you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.
if you still have the old beta, you have to install again both files with ST-link and you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.
Firmware Installation
The latest Firmware is on a separate page : ISE-NIN Manuals and Firmware
Instructions for Flashing
• Connect STM LINK to the Motherboard
• Turn ISENIN on
• Open STM Cube Programmer
• Select ST-Link, select connect
• Select erasing and programming button
• Browse select ISENIN_1.0.2B_1.hex Start programming
!! Disconnect the programmer and restart the ISE-nin
• Repeat the procedure described above and select ISENIN_1.0.2B_2.hex Start programming
• Disconnect and restart ISE-NIN
1.x → wait
Changelog: (of this page)