...
| Tip |
|---|
works best with Scope and good DMM (4,5digits with less than 1% tolerance) |
| Warning |
|---|
make sure your device works without smoke, smell, all LEDs are on, your VCO/VCF/VCA works. before you start, let the TTSH in a room with stable temperature, power on the TTSH for 30 min. before you start the calibration. make sure you have no jumper on kbd/cv pcb header (was used in TTSH rev.1 buildguide) |
Table of Content
| Table of Contents |
|---|
...