What you need:
TTSH rev.1 - rev.3
- a big table
- Hex Screwdriver - i used on my builds hex 3mm screws
- Screwdriver - philips (P2-P3)
...
- ringspanner for the jacks M8
...
- - soldering station to remove the power switch wiring
- glue - power glue (not the paper glue)
- a scissors
- tape - (removable)
- tube shrink
- a pig paper or a clean carton to put the panel on it (TTSH Panel size or bigger) - no bubble foil !!! I explain later
- isoprop - to clean parts where you accidentally attached glue
- water to clean your hands
lets start:
doublecheck the dust cover protection mats, the total amount, check for defects.
the set contains: xxx slips 21 mats
put your TTSH on a table,
...
flip the mat (while the tape holds it on side)
add glue on the front panel - but not too much or close on the slider slot.
...
remove the tape asap, and add some glue on the side if needed, remove with a kitchen paper or ear tips unwanted glue on the panel or use isopropanol.
(later if you figured out how you align the mat, you can try without a tape)
thats all.
let it for one day in a warm room.
...