...
I used thonkicon jacks instead of the supplied jacks (with the pcb)
i only used the Suboscillator output jack and the Suboctave switch (no offset switch, external source jack), on right side its the latest rev.4 build from me.
Use plastic washers on both sides of the PCB if you use metal spacers, otherwise the screw can cause a short at the resistors
as you can see there, I used shielded coax cable to connect the sawtooth output (VCO3 and VCO1), the grounding MUST be only at one end - I used the sawtooth output jacks, that's different to Antonys guide (I connected it after the resistor)
Gallery |
---|