Page History:
| Date | Autor | whatchange | |
|---|---|---|---|
| 15.Jan.2018 | LED-man | 1.1 BOM added, glitch issue, page design changes | |
| 20.April 2018 | LED-man | github link added, firmware link, pcb version added | |
| 09.May 2018 | LED-man | Firmware Versions updated, REV2.0 pcb page added | |
| 18.May 2018 | LED-man | Firmware 1.2.4 with patches added | |
| 25.July 2018 | LED-man | alfa3340 info, patcheditor links, firmware 1.2.5 | |
| 29. Aug 2018 | LED-man | power wiring page created on subpage |
Table of Contents
| Table of Contents |
|---|
...
Display:
make sure your OLED is folow this pinout VCC-GND-SCL-SDA, very often shows the shop the correct pinout but deliver another type.
...
Voice Card Assembly Document. This was created by Lysandre Follet, and has been tested as correct by a couple builders.
| Tip |
|---|
when you have trouble with your voicecards like a whistle on upper or lower card or wrong VCF... the calibration process is not perfect, swap this "faulty" voicecard with another card and run the calibration for the single voicem not for all. if everything wents wrong: insert only one voicecard in Slot1, run calibration (not the tune function). when everything is fine, add the second card to slot 2 and run again calibration - on slot 2, insert card 3 and so on.. |
| Panel | ||
|---|---|---|
| ||
some users plugged the powersupply in a voicecard slot and earn a damaged ARM processor. to minimize this risk, few solutions: put a tape on the voicecard slots 2-8 or use a cable tie to shorten/bind the powercable between powersupply and breakoutboard as short as possible (you can´t attach the powersupply furthermore in a voicecard slot) |
Firmware:
check the download location: http://www.deckardsdream.com/downloads/ for updates, i prefer to wait few weeks before you install a newer version, or check the closed facebook group for comments.
...
http://www.deckardsdream.com/downloads/DD-FIRMWARE-REV1.2.4.bin (newestlatest)
Menu Structure:
DD-MENU-STRUCTURE-REV1.0 (1).pdf
...