...
first test on a bench PSU with current limit on at 12v/200mA
Breakoutboard (BB)
Start with the SMT parts on the rear side and IC4.
here´s an example how this was has been installed by me, add some solder on one pad and heat up this pad while you move a capacitor with a tweezer on to the location, then add some solder on the other side some solder too, normally is no extra flux (fluxpen) is needed , but it depends on your skills.
at the front PCB side install the diodes and resistors on the front side of the PCB , capacitors, IC socketsockets, power socket, MTA156 header,
...