...
Issue: the Trimmer part number from mouser isn't correct, (more infos are in the Issue Lists)
the Case and Panel can be ordered with the PCB set
"The additional parts include:
ENCLOSURE PANEL
RACK EARS
DISPLAY LENS
Sliders
Noise IC
ALL MOUNTING HARDWARE:
SCREWS, NUTS, BRACKETS, STANDOFFS
(Motherboards have all DACS, CPU, audio CODEC, and headphone amp already mounted on them).
Note for builders:
- You need experience in soldering SMT Parts (around 350 SMT capacitors and 24 ICs in SOIC format).
- Tools are required: Soldering Station, Flux pen, magnifying Glasses, Oscilloscope, some pliers, tweezers, PC or Mac for installation of the boot loader and firmware
- Its preferred to have a bench power supply with current limiter for first test
- the programming is made by a ST-link programmer which is in the BOM (in case of DDRM builders - you can use the existing programmer)
...
Date | Location | Type | Identified issue | Resolution | related for development | affected PCB version | fixed Version |
---|---|---|---|---|---|---|---|
30 Aug. 2022 | BOM - Voices | ERROR | the Trimmer Mouser part number is invalid | Line 180: 652-3296X-1-103RLF | BOM update needed | -- | |
30. Aug 2022 | BOM - Mainboard | INFO | the 220uF caps on Mainboard are BI-POLAR - | respect the BOM partnumber | |||
07 Sep. 2022 | Controlboard | BUG | there's no Pinout described on the Controlboard for the OLED - | please read carefully the next INFO section | can be improved with an silkscreen info | 1.0 | |
13 Sep. 2022 | BOM: Voices | INFO | the Mouser BOM show 32x 240pF C0G capacitors for the Voices - used in the OTA Filter. This are 10% tolerance. | you can change the capacitors to Polyprop, Silver MICA, Styrene - with 1-2.5% or match good capacitors in this range with an LCR meter (check the data sheets of the meter) | - | - | - |
Important INFOs before you start the assembling
...
Instructions for Calibrating
• First, put all CENTER DETENT pot/sliders in center,
• Go into MENU, CALIBRATION, SLIDER POT CALIBRATION, run
• (after 30 min warmup), Go to MENU, CALIBRATION, VCO CALIBRATION, run.
• MENU, CALIBRATION, RESONANCE. Follow this from the Jupiter 8 manual Turning Trim1 for each voice (or see below):
or turn Trim TR1 until the self oscillation is off on each voice.
...