...
Panel | |||||
---|---|---|---|---|---|
| |||||
new latest Firmware 1.1.0 released June2023 ISE-NIN 1.1.0 Release.zip > including Install.guide from Black Corp. This version is for prebuilt units and DIY Versions (DIY Version need the initial install as described at bottom of this page, before you can update to latest version)
|
...
Expand |
---|
2.1 you can use the CubeProgrammer and choose USB instead of STlink. - with following steps: 2.1.1 press the SHIFT button on ISE-NIN while powering on the device, the OLED shows "DFU mode", (note: windows users have to reboot the PC or windows can’t recognize the DFU-mode) 2.1.2 on the right upper side in CubeProg. app. choose "USB" and press "Connect"
2.1.3 it must be shown as this result...
2.1.4 then choose on left hand the functions to upload the 1.0.0_1.hex - it disconnects after programming, 2.1.5 restart ISE-NIN with shift button again and upload 1.0.0.2_hex and done.. 2.1.6 ISE-NIN restarts with 1.0.0 in the OLED boot sequence. 2.1.7 go in the menu settings in ISE.NIN and proceed a "reset settings". Don´t forget to upload the additional bank as listed above. (USBMIDI with sysexlib tool etc.) and proceed a "reset settings" again and reboot ISE-NIN you have to install both files, the first file can be uploaded and cube programmer disconnects with an error - normal |
3. Firmware update for rebuild versions:
...
Changelog: (of this page)
...