The Firmware isn't official released (08.Oct.2022), please wait for the release candidate to avoid trouble with functions and calibration.
User Manual:
Firmware:
04.Nov.2022:
new beta, you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.
if you still have the old beta, you have to install again both files and you need to reset preset banks and settings after uploading the new firmware in ISE-NIN.
Firmware Installation
The latest Firmware is on a separate page : ISE-NIN Manuals and Firmware
Instructions for Flashing
• Connect STM LINK to the Motherboard
• Turn ISENIN on
• Open STM Cube Programmer
• Select ST-Link, select connect
• Select erasing and programming button
• Browse select ISENIN 1.0b-1 Start programming
!! Disconnect the programmer and restart the ISE-nin
• Repeat the procedure described above and select ISENIN 1.0b-2 Start programming
• Disconnect and restart ISE-NIN
1.x → wait
Changelog: (of this page)