The Firmware isn't official released (08.Oct.2022), please wait for the release candidate to avoid trouble with functions and calibration.
User Manual:
Firmware:
0.4/0.7 in current test for beta not released for customers
1.0b beta : that’s an beta version, install both files on the devices, start with 1.0b1 and install 1.0b2
In this beta are no presets available !
ISENIN_1.0B_2.hexISENIN_1.0B_1.hex
Firmware Installation
The latest Firmware is on a separate page : ISE-NIN Manuals and Firmware
Instructions for Flashing
• Connect STM LINK to the Motherboard
• Turn ISENIN on
• Open STM Cube Programmer
• Select ST-Link, select connect
• Select erasing and programming button
• Browse select ISENIN 1.0b-1 Start programming
!! Disconnect the programmer and restart the ISE-nin
• Repeat the procedure described above and select ISENIN 1.0b-2 Start programming
• Disconnect and restart ISE-NIN
1.x → wait
Changelog: (of this page)