ISE-NIN Build guide

This page is reserved for the build-guide

BOM: (not final approved by me yet but it matches for sure 99%)

ISE-NIN-BOM-REV1.0.xlsx

ISE-NIN-BOM-REV1.0.pdf

the Case and Panel can be ordered with the PCB set

Note for builders:

1. You need experience in soldering SMT Parts (around 350 SMT capacitors and 24 ICs in SOIC format).
2. Tools are required: Soldering Station, Flux pen, magnifying Glasses, Oscilloscope, some pliers, tweezers, PC or Mac for installation of the boot loader and firmware
3. Its preferred to have a bench power supply with current limiter for first test
4. the programming is made by a ST-link programmer which is in the BOM (in case of DDRM builders - you can use the existing programmer)