Cookie Information, please respect my cookie handling while usage this website, or close this session. click here

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


The TTSH needs  a Gate AND Trigger signals signal with 10/11Volts, otherwise it wont work as designed in usage of the AR/ADSRwith external GATE Signals only.


here was the simple Solutionidea born:

http://www.muffwiggler.com/forum/viewtopic.php?t=112720&start=0&postdays=0&postorder=desc&highlight=ttsh


i offer blank and assembled Gateboosters in my shopofferin my shop the bare pcb and the assembled Gatebooster version:

https://www.diysynth.de/?cat=c2_Pcbs---Panels-pcbs-panels.html

...

Note

in case of  the version with midi implant connector, run connect a 1M resistor from ground to Pin3 of TL072 fix the issue.



preferred  Solution:  connect   

use a screwdriver or other sharp tool to cut a trace  - marked with a blue X in the bottom picture. (dont drill a hole - its a 4 layer pcb)

Connect the gatebooster input with a cable from the GATE Input jack from the ttsh. (its needed to cut the trace from the S/H/Gate switch)

 ( ignore the boost trig out pointer on the picture - use the TRIG instead of GND (wink)

Image Removed

for Rev.1 use the speaker holes to mount a bracket

 Image Removed       Image Removed

for rev.2 and 3:

connect the the TRIG header to the TRIG on the gatebooster.

You don´t need the GND pins ! (except for power)

Image Added


Install a 3 pinheader in the 6 pol pinholes on bottom of the 2x 1uF electrolyte capacitors in the ADSR section and put the gate booster pcb power input on this 3 pin header.

the pcb sit on top of the IC from the AR section. make sure your gate booster pins don't touch any other parts. if needed install a 10mm or 12mm metalspacer as shown in my picture (on left bottom hole only)


Image Added Image Added


other solution for external usage

This Solution use 3 jacks of the multiples:

drill 2 holes in the pcb and mount brackets with woodscrews,  cut the TIP/HOT traces for 3 jacks on pcbat multiple connectors , use one ground (you dont need 3 grounds) run wires from gatebooster to the tip of the jacksuse connect the cables (gatebooster input, gate output, trigger output)

connect the gatebooster power from a module section (there are 6 solderholes, 2x3 rows - test with a voltmeter the voltage output/polarity) run powercable to the gatebooster.







Theory:



TTSH_GATES_BOM.pdf

...